Hi All
I am in need of help (pulling my hair out).
Recently acquired a Denford Easimill with some issues mainly the VFD had expired and the wiring looked suspect.
The control used a GECKO G540...
Type: Posts; User: WOBBLER
Hi All
I am in need of help (pulling my hair out).
Recently acquired a Denford Easimill with some issues mainly the VFD had expired and the wiring looked suspect.
The control used a GECKO G540...
Hi All
Please excuse my lack of knowledge.
Can anyone help me? I am trying to connect my XSY-AT1 to a Gecko G540 using a relay to control the motor with MACH3.
My problem is trying to work out...
Hi All
I am trying to locate a wiring diagram for a DENFORD EASIMILL if anyone can help. I am replacing the original controls and would like to use the original stops etc.
Many thanks, Greg.
Hi All
Can anyone help me?
My Cam program will only output G Code but my control (Heidenhain 155) will only accept M Code.#
Is there a way around this i.e. an conversion program.
many thanks