Did you find a solution for this? I have the same issue on a NV5000. The manual doesn't say much. Already replaced the interlock switch. (see attached).
Type: Posts; User: zacimt
Did you find a solution for this? I have the same issue on a NV5000. The manual doesn't say much. Already replaced the interlock switch. (see attached).
Deciding whether or not its worth the work to rebuild. I remember they are THK SHS linear guides with the QZ lubricator. From Mori both linear guides with rails are 4-5k each. Are you doing this...
Only need it for 3D Surfaces. Only X,Y,X AND I,J,K moves. See below for an example.
*** SHORT SAMPLE ***
PARTNO/0
UNITS/INCH...
Hello Danpil. I've done some research and have found out that much. I did also read that their was, at one time, a post (GPP/VMID fiels), that would output CL code. Do you have any experience with...
Just an update for anyone with the same issues. They are sealed. We will have to replace the rails and bearings. Such a huge flaw for such a strong machine.
Any recommendations on someone who...
Hey Guys,
Sorry for reviving a VERY old thread but I have a friend in need of a post for SolidCAM to output to APT or some type of CL data file. Any one out there can share a post or point me in the...
I know this is an old thread but I'm also looking for someone who can repair an encoder. Mine isn't referencing home in Axis #5 (the elbow joint near the probe).
Thanks!
Hello all, just stumbled upon this thread looking for information on an NV5000 I'm working on. It appears there isn't any active oiling or any way to grease the linear bearings. Is this a sealed for...