Search:

Hi, deadlykitten,
Thanks for the reply. I think this will be the solution if Mach1 (Weeeery oooold!) can understand code translation. I must look in manual for Mach1.
If someone already knew,...

My machine has travel up to 19 inch and in another file (not this I have sent) there is coordinates up to 19,5 inch.
I have G-code ripper already downloaded, but didn't realize how to shift origin,...

Hi, CitizenOfDreams,
Thanks for fast reply.
I want to shift the part.
Because machine's mechanical area is so small that I can't change the origin on the machine itself, it is still near to...

Hi,
I have some g-code files written for bigger machine.
I want to subtract the same number from each X coordinate in the file, so the code will fit into my machine.
Doing this manually is a...

Hi, wireb,
I can't open BL-TB6600 scematic from your post. I get a message: "=" expected.
My Kicad version is stable 4.0.2

Hi,
I have iregulary issue with my mill under Mach1. Sometimes it skips to drill some holes in the file and continues to drill the others. When I check the drill file (looking at the listing) or...

Hi masters,
Recently I have seen homemade ball screw video and I send my drawing about this. Any opinnion with more details will be appreciated a lot.
Here is link:
home made ball screw - YouTube...

Dear Sirs,
Last days I experienced serious problem. I have build plasma table one year ago and works well. But I want to convert it to oxy fuel cutter. Very often I need to activate Run reverse. And...

Hi,
I solved the problem!
I have set max THC to 10 mm and min THC to 1 mm. But the sheet wasn't flat and when the torch references to higher area, and later comes to lower area, it can't go below 1...

Hi,
After four month normal working, my plasma table get weird. (I have THC also.)
Cutting holes seems normal, but when it cuts straight lines, after about 10, 20... sec torch begins to raise...

Hi Tom,
Thanks for the reply.
Can you be more specific with the way to turn off the THC function in Mach. Please explain how to write an M Code macro I can use in the G-code.
mrpeja

Hi,
I'm cutting holes about 2" diameter using arc lead-in and -out. Every time at the end of cut, it seems to me torch touches material. Anti dive in Mach3 is ON.
I think I can avoid this when I...

Hello everybody,
I need Art Fenerty's email adress. I'll ask him to send me THC300B schematic and Soundd Logic's Sensor board schematic (possibly for free) if I buy Mach3 licence. I'm electronics...

Hello experienced people,
I need some usefull and not so expensive nesting software for plasma and oxy fuel cutting CNC machine.
Need suggestions.
Mrpeja

Hi, Torchead,
Is there constant velocity mode when running plasma table with EMC2?
Is there, also, screen for plasma parameters adjusting: piercing, delays, etc. (like Sheetcam)?
Can it run with...