Removed MOCON and video board to measure battery voltage. Battery was at 3.08 VDC. Was actually hoping battery had just died and board was fine but looking like not. I read on another thread...
Type: Posts; User: dwilley
Removed MOCON and video board to measure battery voltage. Battery was at 3.08 VDC. Was actually hoping battery had just died and board was fine but looking like not. I read on another thread...
I'm guessing nobody has seen anything like this before?
I purchased a 98 Haas VF-2 earlier this year and have been slowly cleaning and fixing minor issues getting it ready to run. Machine has been down powered for a while. Yesterday I put the way lube...
When I get back to the shop I will take a picture of the sludge. I don't want this to happen again and clog up the metering valves. They are kind of expensive, hard to replace, and not obvious when...
Here is what the Haas website says.
389350
I recently purchased a 98 Haas VF2 that has been very neglected. I removed the way covers and found large amounts of chips and rust. I found that the x axis was not getting way oil due to clogged...
I'm gonna run to the shop and try it. Hopefully no smoke!
I think this is a picture of what I want. The incoming is on the high voltage left most tap. The output to the terminal strip is on the orange tap just to the right to get approximately 230VAC to...
Here is another picture from google showing what mine looked like when I got it. In this case you don't need the transformer to modify the incoming voltage because you are already in the correct...
Here is a picture I found on google. I think this would be a connection if you had like 208VAC input so the input voltage would be on the far right tap. The 3 wires to the vector drive would be...
The more I think about it I don't know if it is correct. I still have to much voltage to the vector drive (367VDC). I'm worried the vector drive is getting to high of voltage that isn't enough to...
So do the 3 wires on the bottom always stay in the left most terminal? When I got the machine all wires were on the second from the left terminal.
I emailed Haas and they agreed it was correct. So it looks like the incoming 3 phase does not go through the transformer it just uses it as a termination point and the raw 3 phase goes directly to...
I recently purchased a 98 Haas VF2 and I am having trouble wiring it. I am running a PL-40 40hp North America phase converter. I had questions about the phase converter output voltages being a little...