thanks for your help , All problems have been resolved ,My machine is working normally now!
what methed i used
1.panel keyboard function is controlled by PLC with CANBUS communication .When...
Type: Posts; User: looey_bj
thanks for your help , All problems have been resolved ,My machine is working normally now!
what methed i used
1.panel keyboard function is controlled by PLC with CANBUS communication .When...
what can i do ?-------motor not move!
after make a great effort , the machine have gone into the manu! i found that the servo board control multi keyboard function.
softkey function is ok ....
hi
i meet the same problem,how about resolve this issue?
http://www.cnczone.com/forums/dynapath/329230-cnc.html?posted=1#post2004216
If there is something wrong in canbus communication ,computer will give a err message on LED , but all led is flashing normally
today i check all keys of keyboard ,i find no problem.
i use oscilloscope to monitor the singal of keyscan
350240
350242
350244
HI cngbrick
thanks for your help. i am from china. do u have another contact way? such as email. may i write email to u directly?
i will check keyboard lately ,i think the keyboard is ok ,...
today i move the control's POWER SWITCH to the ON positon.the Start up screen ,below,will tell me "PUSH MODE SELECT TO SEE MENU"
When i press the MODE SELECT key,nothing to happen! the operator...
today i move the control's POWER SWITCH to the ON positon.the Start up screen ,below,will tell me "PUSH MODE SELECT TO SEE MENU"
When i press the MODE SELECT key,nothing to happen! the operator...
hi
there is no alarm circuit on overload relay , i have a question ,if no sensor on coolant motor , system how can know overload condition.
DO you have delta 40M USER GUIDE or...
if someone know how to resolve this problem,please help me ,thank u very much
240350
hello everybody !
My old miller 's CN system is Autocon 40m ,today the machine does not work normally. The sreen display "coolant motor is overload" message.I dont know how can i...
I havn't the Dynapath delta 40M operation manual ,how can i enable the rest of option without "*".such as G CODE .
212830
212832
212834
I took the computer apart to show every details,but i did‘nt find the other battery.
212822 PLC board
212824 servo interface port board
212826 serial port board
212828 main board with...
My CNC control system is dynapath delta 40M , i am a newer for CNC. When the machine is powered on, CRT display "“CMOS battery low CMOS display mismatch type、Press F1 to RUN SETUP".
212670
...