Search:

Can i remove the pin by unscrewing the hex head on the end of the actuator or do i need to remove the entire mechanism?

I'm no pro and can't afford a real mechanic to do it, hoping there was a...

unfortunately that's the regular parameters, i have all of those, it's the hidden "pc parameters" that i lost, not the parameter for baud rate...

it's all f'n greek, i'm doing this ALL on my own,...

does anyone in this thread have 6m PC parameters?

i do HAVE the ladder diagram pages... *digging*

i've searched the manuals i have (includes every part number and more) and found no mention of pc parameters... fanuc phone service had me type in something special and they showed up (blank) after i...

this is the punch out from my fanuc 6mhttp://www.cnczone.com/forums/attachment.php?attachmentid=385444&stc=1

i don't have any tapes, but i did make a backup of my parameters, post to follow

i have the regular parameters for a fanuc6m vtc150 but need the pc parameters or it's still a brick

i suddenly find myself in need of "pc parameters" as i didn't even KNOW they existed when i got the pleasure of replacing the bubble ram on my vtc150 fanuc 6m

attached is my regular parameters if...

man this stuff is so complicated....

i've got some more research to do and i'll post another update and round of questions

I just need to find out which parameter, then how to set it

this machine is DOING the tap cycle, i just would like to have it orient the spindle before each cycle, i recall seeing something about it somewhere but i've been all over the internet looking

i...

i'm going to look into that later this afternoon, we work in inches (go figure) so i'm sure it's similar tho

i am not sure of much, but it has the G84 (i think from memory) tap cycle... it does it, just would like it to orient first, i've heard it does it...

I have a VTC150 Burgmaster with Fanuc 6M

i'm trying to do rigid tapping on soft yellow brass, i'm hoping someone can help me set the parameter to orient spindle before each cycle

any and all...