There are supposed to be some books with that but I can’t find them and the boss is gone for a while.
That password got me into the ladder.
I may button this thing up until the boss gets back.
Type: Posts; User: captainkaos
There are supposed to be some books with that but I can’t find them and the boss is gone for a while.
That password got me into the ladder.
I may button this thing up until the boss gets back.
Thanks again!
I am really shy on manuals for this machine and the ladder is password-protected.
I’m still poking at it ????
Thanks.
The operator warning does come up on start up and can be cleared with the soft key.
Hydraulics come up and show good pressure on the gauge.
The spindle chiller compressor and fan pulse...
MRDY is off.
Drives all dashes. (No numbers).
E-stops all out and no e-stop showing on the screen.
The e-stop buttons have multiple contacts so I’m going to verify with my meter.
Edit- All...
Mori MV40 with a pallet changer.
It’s a used machine we powered up for the first time.
The mode displays MDI on the screen no matter what position the switch is in and reset is displayed on the...
I've never seen one like this before.
Fanuc 10-T Mori Seiki SL-3
Obviously a used machine that I powered up for the first time yesterday and made parts on.
On power up this morning the screen that...
We had a connection go bad in our battery box.
Fortunately, we have a backup copy of the parameters.
There were some issues loading them from a PC so I had to load some by hand.
Everything works...
I'm working on an 80's vintage Mitsui Seiki horizontal mill that has spindle lube issues.
It has an air powered lube pump and an air / oil mixer distribution system with a line to each bearing in...
P.S.
Our 2008 V-40 has the same drives and power supply as the 2014 version, but the servo drives are connected to the PS by a few feet of 14mm wire as opposed to the newer machines direct buss.
I...
@drdos- We have a Y connection here. 120 V to neutral on all legs. The old shop had Delta with a wild leg, but the machines didn't whine about it. I guess we just got lucky.
@BIRDTOOL- YES!!!!...
I'm not familiar with your machine, but some of mine have a "second limit" switch that will let you jog or hand wheel out of the oh crap zone.
A simple option, if you can get at it, is to E-stop and...
Thanks, Dan. That's what I think too.
We had the power company out and everything is within spec. The lowest voltage we read was 207 at the drive power supply.
Its rated input is 200 to 240 but the...
We have four Leadwell mills. An MCV-OP, two V-40's, and a brand new, just powered up today, V-20.
The V-20 and the newer V-40 (2014) both have SV0438 (Z) INV. ABNORMAL CURRENT alarms when we rapid...
I'm guessing it has a Fanuc spindle drive. If you post the model number of the drive (not the control), I have some manuals for some of the older drives and I might be able to find something to help....
This is the same machine from my last post, a Kita 500.
The abnormal current alarm was fixed with a new motor and a drive, but during the repair the encoder connector for the pallet changer was...
Hello fellow metal heads! This is my first post.
I'm working on a Kitamura HX500 that has had a hard life before we bought it.
It leaked coolant into the connector feeding the B axis motor, and I...