Search:

Problem solved!!!
Found that there is 2 parameters that have to change and then it worked.

Hey everyone,

I am trying to get the Tool Life Counter to work on our NLX2500/700. I have done all the things that the Tool Management book tells you to do, Building the tool shapes, how there...

We have the issue fixed the whole issue was that the wiring was wrong and also cause of the wiring issue it fried the board. thanks though

Thanks for the reply cmp79.

That is close to what I had programmed.

I should have posted again and stated that we are under the impression that the wiring interface is the problem and both...

We just purchased a 2014 NLX2500/700 12 station static turret. We have a multi-bar barfeeder hooked up to it. We love the machine has alot of torque for drilling what we needed, but the only thing is...

@ deadlykitten Thank You for the reply. I have looked at this and it seems that I am getting all I can get from the machine. Thank you for the info, much appreciated.

I was just wondering if anyone knows if there is a parameter that controls the speed of the rapid moves of X,Y,Z,and A. Our machine just seems to be a little slower in G0 movement than our MB4000.
...

Fanuc Automatic Programming Tool. I have not used FAPT in over 15 years

Ya that was a typo here. At the machine it is in there

Ohh Crap, I gave the 120" bar change program not the 240", my mistake well the program is all the same but the #100 macro is 231 not 111. Well the issue is still there and was just hoping that...

I will give this a try as soon as I can get back to that machine.

We are using a Iemca Boss 332E barfeeder. The bar lengths are 120", 144", and 240". The min remnant length is 9". So we have to calculate how much of the material has to come off the bar so that it...

With out going to far in depth of my process. I really wanted help to understand why its defaulting #142 to zero when I get to #120=334 or #120=357 or #120=204. Like I said this is a very basic...

The funny thing is that I am not getting any error messages. When I when to the 3rd digit on my #120 call the system just went to a default zero call in the #142. I don't understand why this...

Hey everyone,
I have been writing macro and complex macro programming, and have come into a issue with our Tsugami SS-32 with 31i control. This is a quick through together test that has failed and I...