Hi,
I'm new to this company and I'm noticing some variations in how things are done. i've alway programmed a mill cut with wear comp, and no matter how many passes I made, only called out the D...
Type: Posts; User: Chappyd
Hi,
I'm new to this company and I'm noticing some variations in how things are done. i've alway programmed a mill cut with wear comp, and no matter how many passes I made, only called out the D...
Hi all,
I didn't see a forum for these machines listed, so I thought I would try here. We have seen a Supermax TV116 machining center for sale at what appears to be an attractive price. The...
Thanks for the reply.
The actual alarm message is:
0T007 Y + OVERTRAVEL (HARD)
0T008 Y - OVERTRAVEL (HARD)
The Y axis is physically in the middle of it's travel. I tied looking in the...
Hi all, We have a KIA va-50 cnc mill with a fanuc 10 control. Lately we have been getting this alarm on start-up in the morning. The table is roughly centered in it's travel, so it's no where near...
Hi all, I have a KIA VA-50. It's pretty old, and one of the poximity switches on the y axis limit switches went. We were able to order the part, but when I went to replace it, the wire color coding...
We're working on some mag housings. Most of the job is going great, however, we have to drill some .040 holes about an inch deep. The boss was saying it would be good to get some lubrication while...
Thanks very much Al. I'm also using, should have said so at 1st, a 9 pin to 25 pin adapter, it's the only one I could find. Looking over your pdf file, I can make my own to match the 9 --->25 pin and...
Jumper out the 10. 10M control I assume.
jumper on the 4 to the 5 pin
on 6-8-20, no wires connected. Is this correct?
Sorry to be such a noob
:confused: I'm new to this machine, and I'm trying to set up a lap top pc to send and recieve progs with a usb-serial connecter. Is this even possible? I keep getting the alarm SR820 DR OFF (1). I...