Good day
I am trying to cut letters off 25mm clear acrylic using a CNC machi
My bit is 6mm O- flute, new
I tried 18k spindle speed, 5000 feed rate , 5 steps of 5mm deep each
The bit gets...
Type: Posts; User: Nissim6811
Good day
I am trying to cut letters off 25mm clear acrylic using a CNC machi
My bit is 6mm O- flute, new
I tried 18k spindle speed, 5000 feed rate , 5 steps of 5mm deep each
The bit gets...
Good day .
I am wondering if there is anyway to use a
tapping self reversing tool with my cnc router?
The minimum speed of my spindle is 3000 rpm.
Many thanks in advance
Thanks mate
It sounds a good idea
I ll give it a good shot
Thank you
Good day
I have a CNC router machine
I am trying to make a 1mm deep V groove along an ACM 4mm 2400x1220 panels
I have good suction under the bed
I did a clearance area' 1mm the MDF on...
Excellent
Thank you for sharing your knowledge
Nissim
Thank you very much for your reply.
Do you mean that I shall route off 0.5mm from MDF of the actual plastic bed?
Hi there
I have 1325 CNC router with a vacuum under the bed .
I am trying to route a 3mm V slot onto 4mm ACM .
I find that the slot dept is not consistent.along the material.
This is...
Thank you so much
Your reply is most useful
Nissim
Good day
I have a CNC router
I want to drill 9mm holes on an ACM ( Aluminium Composite Material ) total thickness is 4mm , aluminium layer thickness is 0.4mm
I do not expect to drill ...
I bought a cnc router from igoldencnc in Jinan.
After sale service is non existence .
They can't speak any English .
They employ idiots to deal with overseas buyers.
Take my advice
Beware...
Thank you so much !!
I followed your advice and set up the feed speed
Its perfect now
Thanks again
Nissim
Thank you very much for your help
I attached photos
Hi There
I have a cnc machine but very little experience.
I want to cut 3mm alumiuim with a pattern on the surface (non slippy pattern )
I tried 6mm end mill tool
I set the speed to 6000...