Search:

Does nay one know of any people that can support (Electric/electronic) the Grundig ELTROPILOT L2 control. This one is fitted to a Gildemeister MD% Shaft lathe (1992). I have tried Heidenhain UK and...

Hello
I am looking for someone who has good knowledge of ELTROPILOT L2 control. I have a Gildemeister MD5 shaft lathe that has been giving problems but just recently is displaying excessive heat...

I have a fault on a 1992 Gildemeister MD5 lathe fitted with Eltro Pilot control and Indramat Drive. I can not find a company who may specialise and support this product. Can anyone suggest any...

Visited customer and investigated. When the axis pair are asked to reference the axis move in x axis then z axis. (It is a called up programme and one axis runs after the other). I assume that the x...

The X and Z axis reference does not "Complete / finish". This machine has left and right machining slides. The left machining slide (X and Z) can be referenced and on completion the controller says...

Hello
I realise that this was a very old post but as it is still listed, so can I offer this in reply and to all SWEDTURN, SMT Machine tool, SMT Sajo lathe users, - SMT Machine Tool is based in...

Hi Barry. Do you still have this SWEDTURN lathe?

Regards
Dave H.

Hi Darryl
Firstly thank you so much for taking the time to suggest a course of action regarding this Doosan NM510 fault. I shall be revisiting the customer next week, and although I am not familiar...

This machine has a "Cam" type ATC system. Now and again the ATC fails to complete and has to be recovered manually by winding the ATC motor to get the arm back to home position. Doesn't always fail...