Search:

Is it possible that Low Voltage power Supply can't generate enough power for processor an videocard?

There is the problem with GT-20, it is reboot immediatly after press button CYCLE START in Graphic Mode. That is the problem?
https://youtu.be/ADQEOHNKNog

This setting was removed to prevent possible crash during restart program. It is recommended to use other tools, like subprogram.

Advise, please, axial test bar for BMT65 HAAS tool turret. I found only BMT55 Test Bar -32mm (WTO) ...

Do you resolve the problem?

There is so much oil on the spindle motor inside column VM-2, I can not find where it come from - oil around Tool Reliese Piston, on the motor and fan. Air line has not additional oil filter, but it...

We have higher spindle load on HAAS ST-20, 10-12% at 1000 rpm, 20-22 % at 2500 rpm. I have checked belt, tension, encoder belt, it's OK. Where is noise from the spindle motor pulley, it seems bearing...

Yes, it's extremely loud.

It was successful?

One more question: is possible to compensate backlash on X-Axis of ST-40?

To make this I need disassemble machine almost completely(( In addition it's not small (ST-40)

Yes, but it is 300 or so mm long, and when I measuring in different places of Z-Axis, I determine different deviation. Is it possible to measure straightness of linear guides on all length?

How to check straitness of linear guides of this machine? The spindle centerline is not parallel to wedge motion on Z-axis in some places, I suppose the linear guides are not straight.

Is it possible to use (and calibrate) Renishaw OMP-40 without OTS toll setter?

The problem was in wrong measurements. Z-axis column is OK:)

How to make alignment of squareness of Z axis motion to X and Y axis on VF-3 machine? physically?

Problem was in Parameter 315 bit 1 NO SPIND CAN CYCLE

I going to change encoder, but, interesting, generally it works OK, alarm appears when I turned spindle by hand in one direction, and then in opposite direction((

How frequenly LOWGEAR BOX ALARM is appears in HAAS mills?

I just check connections and connectors itself.

I am not sure, because here http://www.cnczone.com/forums/showthread.php?36624-Alarm%20235%20Spindle%20Z%20Fault Alarm appears again, after new encoder was installed:confused:

Problem was in Y2 measuring scale..

It is intermittent alarm 235 SPINDLE Z FAULT on VF-5/50. Usually during program run no problem, but when run spindle in MDI or MAnual mode CW, and then another direction, even by hand, appears Alarm...

Thanks all for help,
I have TS27R, but I loaded mistakenly program for wireless probe. I changed program, and now probe works correct. Wired probe always "open", wireless are closed after probing.

I tried to reload few versions of macro programs, but it doesn't help. Periodically appears alarm PROBE OPEN, when start probing.

Alarm OTS swith off failure

At the end of probe calibration I get alarm 1001. Program works OK, but at the end, instead message PROGRAM END, I can see RUNNING, and then alarm 1001. May be problem with macros? How to fix it?

It's HAAS TL-25

Spindle is starting during G83 cycle with live tool and C-axis engaged. C-axis and spindle are try to work at the same time:confused:

We have problem. Press brake GASPARINI x-press 100 can't find reference point only on Y. Beam goes through limit switches without any effect. Switches passes signal to the electrical box and laser...