Search:

Gary,

I'm having the same problem now.

Did you solve this?

Any input would be appreciated.

Thanks

There is no macro-variable screen. I pressed "macro" button nothing comes up.

In the manual, it says to press "SET" button twice, it'll show macro variables. But that isn't working either. I press...

Thank you so much for helping me.

I added that in the program and no error.

How do i see the value?
And how do i reset the value?

Thanks

How should I use the parameter #500 in the program?. I'm new to this using parameters thing.

Should I just add a block "#500 = #500 +1"?

Thanks

Hello,

I have a FANUC 6M controller and I'm not sure how to count the number of cycles run.

I'm looking for a parameter that can be reset after every setup, so that we can keep track of how...

Thank you. I'm thinking of grinding an end mill or using a broaching drill like RCaffin Suggested

The trepanning tool I have is made of one cutting edge. It is similar to the design you have. I made it so that it just makes one pass (width of .15"). But I'm getting a bump on the surface where it...

I haven't tried the broaching drill yet. I have a Haas SL20 and i don't think it's rigid enough to take a broach drill. But I might be wrong.

I fabricated a trepanning tool with HSS.

Chips are breaking great. I don't have a problem with that.

But the problem with that is it's leaving a rough surface finish and it leaves a bump of a...

I contacted Thinbit. They said they cannot help us in the situation.

Hello,

I have to groove a 1.01" O.D X 0.71" I.D. to a depth of 1.44" on 12L14.

Does anyone have any idea or a tooling recommendation for accomplishing this?

This is turning out to be too...

I have a Fanuc 6M control for our Mazak VMC. I have a question regarding the parameters.


I'm not sure what the following parameters does


1. Time constant of exponential...

Hello everyone,

In our company we have an OKUMA lathe. On this lathe, we run parts that needs to be machined on both sides. So after finishing the first side on a part, we use M00 on the program...