Search:

I have a Larken System 100 with a 10-hp spindle and automatic tool changer. I have been able to cut wood, plastics, composite tooling products, aluminum... pretty much anything non-ferrous on it.

After reading my install manual again, I've discovered that I have the "red" hasp, and apparently that is intended for network installation.

As I understand it Mastercam offered a Version (V8) and later X8. I'm trying to run the X8

Thank you for responding. I was wondering if that might be the issue, or perhaps I haven't set up the HASP properly?

Greetings,
I am new to Mastercam, and I've just installed version X8 on my laptop. The attached photo shows that I'm able to import a model, set the stock settings, and choose the material. But when...