I haven't had any luck in my search for a hi speed spindle drive pulley, (48 tooth, 7500 rpm) for my hi torque machine, (56 tooth, 6000 rpm) so I'm thinking of making one, or modifying the existing...
Type: Posts; User: Azor
I haven't had any luck in my search for a hi speed spindle drive pulley, (48 tooth, 7500 rpm) for my hi torque machine, (56 tooth, 6000 rpm) so I'm thinking of making one, or modifying the existing...
Just ran the first job on a 1996 Torq cut 22 converted to Centroid control. Love the control! All the panels and covers and guards are still off including the head/transmission/tool clamp.
With this...
Hard drive finally died. I have system backed up to 2 floppys, but evidently I need an installer. Machine was refurbished in 2001 by South Bend. Dead hard drive is '95 vintage. Can anyone give advice...
Hard drive finally died. I have system backed up to 2 floppys, but evidently I need an installer. Machine was refurbished in 2001 by South Bend. Dead hard drive is '95 vintage. Can anyone give advice...
Has anyone done the calibration routine on the system set up page? My actual speed is quite higher than program or jog speed. I just had the steppers and encoders and main pump and spindle motor/pump...
See if you can see the start point of the laser, where it burns through first ,then interpolates the hole dia, then finishes where it started. I'm guessing thats a hard spot and you're pushing away...
I've rebuilt the spidle load adapter and had a little vibration on my new bearings. Is anyone using a hydraulic drive Magnaturn with rubber vibration mounts on the load adapter?
South Bend Magnaturn 1218. I just replaced the bearings in the load adapter, between spindle pump/motor and spindle. Lathe sounds great, but I noticed in my new 1218 parts and assembly manual that...