Thank you!
The machine works again. After holding down the three buttons, I waited 30 seconds. Then I hit Estop. Then, a couple of seconds later, the emergency unclamp message came up. I continued...
Type: Posts; User: roboticist
Thank you!
The machine works again. After holding down the three buttons, I waited 30 seconds. Then I hit Estop. Then, a couple of seconds later, the emergency unclamp message came up. I continued...
Thanks for the help.
I hold all three buttons at once. Then I only wait about a second and hit release.
Is that incorrect?
I had posted this to another forum, so I apologize for posting in two places. The other forum is not on CNCzone.
I turned on my Hyundai Kia SKT 100 after about 3 months of it not being used. I...
Hello,
I have a tape drill mate that I have been using for about nine years as a secondary machine.
I sold my larger machining center and wish to use this as my primary machine, so I am using...
What material and process is best for making compass needles?
We are making some compasses to spec, but are stuck when it comes to the needle. The spec does not designate the material, just that...
Hi all,
I have an older CNC Mitsubishi ram EDM (M25) with a tool changer and I want to start converting it into a small automated CMM.
My goal is three tenths to half a thousandth accuracy. The...
Hi all,
I'm brand new to the forum. I'm a toolmaker who had a shop until 1997 (32 machines), and for various reasons returned to school. I am now opening a new shop. I've purchased (financed) a...