https://we.tl/t-zO9ici6A2d
Type: Posts; User: renato13
https://we.tl/t-zO9ici6A2d
Hello.
* I want to connect the inverter Jaskywa VS-616PC58 / P5 to the Mach3 USB Motion Card (AKZ250) to Spindle speed PWM output. I would like to have a speed control.
* Please, if anyone can...
Hello.
* I want to connect the inverter Jaskywa VS-616PC58 / P5 to the Mach3 USB Motion Card (AKZ250) to Spindle speed PWM output. I would like to have a speed control.
* Please, if anyone can...
Home
Fanuc 3M drip feed upgrade chipset for A16B 1000 0010 | eBay
FANUC SERIE 0-MC
SOFTWARE: 0469-21
TYPE: A02B-0098-B511
1. Drilling with CANNED CYCLE doesn't work. During the course of program, no error is shown – the program just skips the lines where the...
You need instructions on programming or on machine? First I need to scan. Maybe I will have time over the weekend.
HI
Check you this 4 parameters; No 4 for X axis, No5 for Y, No 6 for Z, No 7 for 4TH or W (second z axis if you have two z axis)
http://www.shrani.si/f/2n/lO/FR3xmFN/scan0005.jpg
Sorry for...
I will check tomorrow in manual which parameter provides a step motor in individual axis.:)
Hi.
I have two machine with Fanuc 3000c controls. I use PAC 3 program to communicate DNC through the LPT port (in DOS mode) Programmable in 1 /100 millimeters. Punctuation is not used! 1mm=100 ,...
Thanks.
Unfortunately I'dont have G61, G64, G09 commands. When writing commands appears ERROR NO. 10 (unusable G code was commanded)
Thanks.
Unfortunately I'dont have G61, G64, G09 commands. When writing commands appears ERROR NO. 10 (unusable G code was commanded)
I have a NC milling machine FANUC with FANUC 3M control (rom version D71-04). I have a problem when milling sharp corners. The corners are not sharp or edged but are rounded instead. The machine...
Hello.
We recently bought the upgrade chips for Fanuc 3M . After the upgrade (version D71 - 04) it is supposed to get direct DNC control between machine and PC (drip feed) and thus no memory...
Thanks for your answer. But my 3M (version of software D71-04) have only 99 parameters. :confused:
Hello.
I'm upgrade fanuc 3M (replaced 10 control chips on the motherboard). Machine now working 3-axis control simultaneous only on linear (G01 X50. Y50. Z-50 F3000) I' need to work helical (G02...
Hello.
I'm upgrade fanuc 3M (replaced 10 control chips on the motherboard). Machine now working 3-axis control simultaneous only on linear (G01 X50. Y50. Z-50 F3000) I' need to work helical (G02...