Search:

Sample of G-Code & Where you are having trouble?

See G47

I have used it in the past. Make sure your protocol matches at the machine.

And just where are you having trouble? N37? I don't see any G40 being used either.

I would suggest taking a look at this area in your post and make your changes

ltlchg$ #Toolchange, lathe

Care to post some g-code?

Did you delete the % at the end of your program?

Work Shift, Shifting the WORK DOWN in the Negative direction, NOT the Tools

Set lead-in and lead-out to 90 degrees

Has anybody come across a post for a Haas or Fanuc that actually outputs tool edge code with proper radius values.
I have always preferred using blueprint values.
Downloaded TONS from Gibbscam but...

Hit it with an open flame or some heat

Single Lines?
Single G-Code? Such as a G47?

Attach and image perhaps..

A No. 5 Center Drill will make a MAX 0.4375 Diameter Chamfer. The example on this page [URL="http://www.webmachinist.net/centerdrilldimensions.html"] may NOT work

Threads on a Shaft and Cosmetic Threads | SolidWorker.com

I took some time to review the posted excel file and found the numbers were not the same as what I use when programming. So I have added some additional information. Let me know if I'm on the right...

These have worked for me!

http://www2.coromant.sandvik.com/coromant/pdf/metalworking_products_061/main_e_7.pdf

SDP

Nice set-up...
Be sure to take the play out of the moveable with the adjustment screw.

I also used a long nut clamped onto a block with a square head jacking screw & used it to seat the part into...

Glad to see somebody pointing out the issues with manufactured goods!. After all I am a consumer also, I wouldn't put that money out for that kind of product or service.

Unfortunately...It isn't that common :)~

Since you can not increase the feed, Reduce the speed

I would go solid myself

The answer is no to your question. You are going to have to do some trig to figure the values out.

Care to post an example?

GibbsCam seems to becoming more & more popular in our area.

Drawing can be a struggle until you understand it, but works well with solids

The difficulty lies not so much in developing new ideas as in escaping from old ones.

John Maynard Keynes

I would suggest placing the part origin at the TOP of part (finished Z face)

Make sure you set the clearance plane to 1.0" on the material setup page.

I hope this helps, if not perhaps posts...

From what I remember on the Matsuura that I ran it was a G93 to turn the Mode ON for tapping.

e.g.
G43 H6 Z1.0
G93 (Mode ON)
G98 G84 Z-1.0 R0.1 F0.0625 S800
X0 Y0
G94 (Mode OFF)
G28 G91 G80...

1/2"-13 2B Pitch Diameter is pitch diameter of 0.450 to 0.4565, or an average of 0.45325 with a tap drill size of 0.4219

So if your pitch diameter is .4715 to .465, or an average of 0.46825,...

another question to consider....in your offset page for the cutter idameter offset
IS this value a postive or negative value??

D01= -0.500 or 0.500???