Search:

I believe that you have a aluminum bracket and there has been many that have it welded. There was is enough play to realign it to the spindle by slowly bringing it down for a tool change and pausing...

rofiksumartopo It sounds like you lost your plc perameters because of battery back up dead. Replace the battery and call SCM about sending you the plc perameters file and steps to load back into...

G0 G49 G40 G17 G80 G50 G90
M3 S2000

G0 X0 Y0 Z0

G0 X0 Y2.375 Z-1.165 This is the problem. Z should be at Z0.1 in rapid
G1 X14 F20
G1 Z-1.165 This should be here in cut mode
G0 X14 Z0.1...

If the computer is 20 years old it might not work in a newer computer if your old one is an ata33 or 66. Look at the cable, they might be different.

BENDIX AMP CONNECTOR 4 PIN and 9 pin ALLOY. They are easy to use and heavy duty

I agree with Tim. Never change the battery with the machine off. One time I was changing the battery and had a power failure and lost everything. Go Figure. If it wasn't for bad luck I wouldn't have...

My Bad. Yes Power should be off and drained first. Didn't think anyone would do this live.
But you never know. Good Catch Jest

There are a few things that can cause this problem. You need to go in the bios and see if the bios can see the hard drive. Most computers today only use the battery for the time set. If the bios does...

Has same problem and found power supply board had burn marks. You need to pull the power supply board out and inspect it. You might find the problem there.

Try this connection. See Attached

There seems to be a ground problem. Noise is causing the problem. Check to make sure you have good grounds and the wires that are running your spindle is insulated away from stepper motor wires in...

Turn machine on. Home it. Loosen the bolts on the gantry. Move back and forth at a slow speed a couple of times and tighten up bolts. The groaning or humming is caused by the servo's fighting each...

The rule that I follow is (bit diameter times 600 in MDF and partical board. Never go deeper that 3 times the Bit Diameter.) (Bit Diameter times 450 in solid wood. Never go deeper than 2 times the...

I do believe the password is MORBI. Try it and let me know if it works

Glad to post to CNC Zone. I have been in business with CNC Woodworking for 25 years and will try to help out with questions