Search:

I think I have been using the same type, DTE 32 turbine oil. I have not checked the level because I just replaced the air/hydraulic cylinder a few months back. Some of the early ones (mine) had air...

I appreciate the information. I did get in contact with sharp and their tech said the same thing.... maybe making a change in the parameter would help also.
I would like to check the machine gibbs...

I was just curious if anybody else had a similiar problem. During a part change, (program ended M30, waiting for cycle start) I noticed that the servos (I'm assuming) tend to make a a noise that is...

I've been meaning to look into a gas lens...I'm going to start with backing down on the Argon and pushing the tungsten back and buy a lens.
I think the tunsten was sticking out about .250+.
Speed...

To start, I'm a novice, but here it goes.
I'm having problems with welds becoming contaminated while welding exhaust tubing.
1. joint clean & sanded
2. argon at about 30 psi
3. cup is about...

Sharp has a new tool change macro you can try either via internet or through a flash card.
I used the macro for a while and the the same thing came back after a while. (FYI in the trouble shooting...

Actuator/cylinder is not releasing the retension knob fingers do to lack of travel. Any suggestions?

I have a sharp 2412 vertical machining center (10 pos tool changer) and it has developed a problem clamping the tool.
It appears the cylinder/actuator is not letting the collet fingers come down...

Haas machines are very user friendly, but linear ball slides don't dampen heavy cuts like box ways. If your pricing around remember that the low price Haas is with out anything. (chip gaurds, chip...

I'll give them a call. I agree with the coolant, because I put the wheel under a microscope and it looked like was grinding solder:) Packed in. Anyway I have a part time thing going and I also grind...

Any suggestions on wheel type and bond? I'm using a B&S #1 ID/OD grinder to remove .005 of material and the wheel (14") keeps loading up and screaming. Talked to Norton and they say you have to push...

Hi Tim, finally got a hold of Charlton today and he is sending me a new (M06)tool change (9001) macro. He asked asked how old it was (2003) so maybe they found something in their macro/software that...

Was wondering if anybody had any ideas on a intermittent problem with the tool going into full rapid traverse (even though the rapid traverse over ride dial on the control is set at 50%) during a...