V17 is stuck on Win7 32bit, no higher. Just have to let it go. Whereas V21 can work all the way to Win10
How do you like V32? I find it strange that V33 is out so fast.
Type: Posts; User: centaur91
V17 is stuck on Win7 32bit, no higher. Just have to let it go. Whereas V21 can work all the way to Win10
How do you like V32? I find it strange that V33 is out so fast.
I was able to install and use V17 successfully on Win7 x86 but not Win7 X64. V21 installed on Win7 x86 but crashes on startup. But something baffles me, V21 does not run on Win7 x86. You would...
thanks.
I hope the tach is easy to reach once it is opened up.
412690
Not getting those errors anymore. I was able to grab the x axis ball screw and move the table back and forth and was able to CS and home the table with no errors. Now the x axis motor is making a...
I am assuming even if I rotate the resolver, the X axis position will be close but does the Fadal find the orignal exact X position of the table. I have jigs that I have save the X Y locations and...
voltages test find for the x axis from the side panel. Pull the J2 bullet connector out and measured sightly over 1.7V
I am about to remove the X axis resolver, but is seems to have a shield over...
I know the resolver for the Z axis needs to be rotated for spindle / tool changer alignment , but does the X or Y axis resolvers need any form of alignment after a new one is installed?
X axis fault Error #1 but gives error #3 when amp card swapped
I was doing a everyday machining job when all of the sudden the machine stopped and displayed a X axis fault error #24, tried to jog...
Thank you.
I was convinced it was not silicone. Silicone does not peel off as it ages, it is a pain to scrape off also. I will search for this Sikaflex.
I am about to scrape off some of the aged seal which peels off and looks more like caulking. What is the best sealer to use to replace the old one. I don't think the factory seal is silicone...
Has anyone done peck drilling with FC V2.1.4 and other versions with G81?
I mounted a drill bit on a tool holder on the lathe slide would like to be able to automate the drilling instead of...
How do you determine the tools offsets for each turning tools? The manual does not give single example how to do it.
I have a lathe with 5 tools in a gang. I would like to use them all but not...
Thanks for nobody's help on this forum that is supposed to be the best. Got it fixed on my own.
The flashing LED is on the 1010 card in slot 9 which is the X axis, although the Z axis has faulted.
Why would this card LED flash when the 1010 card in slot 11 should be flashing?
My VMC15 went down yesterday and just did a post describing the details in this post.
http://www.cnczone.com/forums/fadal/150834-z_axis_fault_error_16_a.html
I hope some experts here can help...
The mill has just started a new job and as I turned my back, I heard an awful clunk and bang. My VMC15 has just dropped my new tool holder onto two vises below it. I didn't see exactly what...