Search:

HALLO

I`am new with siemens 840D controller.On lathe i should make m8 thread 25mm deep in the center with thread drill with cycle84.Can anyone help me.

Hi
Mr. OkumaWiz
I remove M66 from program and also try with 6 digit on T (T010101,030303) but dont work in graphic. Heres are pictures of the tool graphic setup screen.

Best regards

Hallo

Here are the pictures.All operation in graphic do just tool that is curent selected in turret .

Hallo again

I checked everything as you described and I have only one offset on X , Z for each tool. As I described when I test the graphics with maschine lock it shows me only the tool that is...

Good morning Mr.OkumaWiz

I have another question
When I test the program in the simulation mode with machine lock button it does not show me the tool change but it simulates only tool that is...

Good morning Mr.OkumaWiz

Sorry for such a late reply .
Like you said i changed two bits -#7 bit 5 on 1 and #8 bit 3 on 1 and everything now works perfectly.
I can turn turret in manual mode...

Hello

Mr.OkumaWiz

I found ( i think) problem for alarm-a 1029-41 svp sa power circuit low voltage TA.
When the operator changes pieces on the machine and the door is open for more than 1...

Hello


Thanks OkumaWiz for help.
I'm sorry I didn't answer for a while because I was on vacation.
YES the spindel rotation problem is solved.Like you said it was a optional parameter Nr.34...

Hello

Mr. OkumaWiz
In attachment parameters from machine from today.

Hello

Thanks OkumaWiz for the advice and help so far.
According to your instructions, now the limits on A Spindle 2 and A Spindle 1 match.But still i cant turn the turret in manual mode.I will...

Hello

Again thank you mr.OkumaWiz to helps me with my problems.
I try to MDI turret to limit and than switch to Mid-auto-manual and when I push index button nothing happens-turret not index. Is...

Hello again

After we mount air conditioner is the temperature in electronics cabinet ok , but still we have the same alarm-a 1029-41 svp sa power circuit low voltage TA or TB but only when the...

Hello
First i must thanks to OkumaWiz for help.
I check data and switch is working.About soft limits i thing they are good , because i get light that confirm that limits are reached , but still...

Hello guys

In our company we have an old Okuma twin spindle turning centre.Could anyone tell me, what this fault mean: alarm-a 1029-41 svp sa power circuit low voltage TA .
The book with alarm...

Thanks Gazzo. I’ll try it tomorrow

Hello!

I’ve got a problem with setting of zero points at the machine DC50V (controller dialog 112). I need 6 zero points for each pallet. But I only have 6 all in all (G54-G59). How should I write...