+1 for ISO30 It's far more common and ISO30 collets are available (metric only though), that I find handy to gain a little more headroom:- ...
Type: Posts; User: nick952
+1 for ISO30 It's far more common and ISO30 collets are available (metric only though), that I find handy to gain a little more headroom:- ...
Hiwin lubrication guide is here:- https://www.hiwin.com/pdf/lubricating_instructions.pdf
In this guide (on page 27), they suggest Mobilgear 630.
Mobil specs here:- ...
Is this the sort of slot?
What version of Alibre are you using?
If you are using the latest version of Alibre Design (not Atom 3D) and it's what you are trying to do, I'll upload the file to my...
Also using a "DownCut" milling cutter helps a lot on thin material.
I know these are listed for wood, but I've used similar here in the UK on steel before without any problems.
2 Flute Downcut...
Hi,
Try searching for "Vertical Swing Grinder" such as this example:- Mac Far Vertical Swing Grinder – Mullin Machinery
Or "Vertical Spindle Surface Grinder" :- Gate - Vertical Spindle...
Hi,
The Facets could be in the model, so the CAM just outputs them.
Make sure that the CAD system has the Curves/Facet resolution set to the finest possible, then re-generate the model (A lot of...
Hy Buoyen,
Not free, but I would recomend you check out CamBam.
I use Geomagic (Alibre) and ViualCam Professional for Geomagic, but I have a licenced copy of CamBam, that I still use now and...
Found on another forum:-
Figured it out eventually,
I had to remove the clamp at the end of the plug preventing the wires from getting pulled out
then screw the plug back into the socket
then...
Have you confirmed that Bobcad is actually using the Nvidia card and not just defaulting to the Intel onboard graphics?
Nick.
Not quite, the ESS's Port #1 pins 2-9 are fixed as Outputs, where as Ports #2 and #3 pins 2-9 can be configured as either Input or Output and I think Ports #2 and #3 revert to Input by default when...
Hi Pete,
Thanks for trying to replicate the problem. This does seem to be an issue with the electronics on my machine.
I will stick with Port #2 on the ESS as this works perfectly, but obviously...
Hi Pete,
Don't know if there are ready made available, but these guys can make custom ones to fit
Telescopic Slideway Covers ? Beakbane
Nick
Thanks every one for taking the time to reply and suggest causes and possible solutions.
My reason for posting was only to try and find out if this is an isolated issue, confined to my machine, or...
Mactec54 and neilw20,
Thank you both for your input.
Bear in mind that these machines are sold complete and ready to run (once you add a computer and if needed a motion controller).
The...
Hi Mike,
Thanks for your input, but as I said in my post, this only happens when power is removed from the ESS (a motion controller made by Warp9td, for Mach3 and Mach4), even if the ESS is NOT...
Hi guys,
Just trying to figure out if there is a general fault with these machines, or just a faulty board in mine.
My setup is a 2016 Syil X5 Plus, running Mach4 with Ethernet Smoothstepper...