48" X 40" capacity. Very accurate and easy to use.
With slatted table attached to heavy duty cart. Includes massive ventilation system.
Super large extrusion with hardened rail inserts and rack...
Type: Posts; User: The Geekineer
48" X 40" capacity. Very accurate and easy to use.
With slatted table attached to heavy duty cart. Includes massive ventilation system.
Super large extrusion with hardened rail inserts and rack...
Thank you very much for the lead. Sent a notice off to Russ for the 'dohickey'.
I've watched about 25 and learned a lot from his videos -guess I missed No. 53.
I must have gotten a pretty well...
Hi all,
Newbie here with my 50W Chinese blue laser cutter
Has anyone recently /designed or built a way to measure power output?
Absolute wattage would be great but even a relative measurement...
Hi Bob - thanks for the reply.
There was a hard stop when the second nut came up to the threads. Not a tight fit that needed 'persuation'. I tried claming the nuts axially to try to minimize...
Has anyone experienced a double nut that only screws half way on before getting stuck - at about the point that the second nut starts the thread?
Not sure if there is blockage between nuts where...
Hi all
I'm the middle of a mess here so any/all help appreciated.
I'm swapping out my 1605 ball nuts for double nuts.
The Y axis was no problem but when I was putting the X axis double nut on
its...
Hi guys - having an issue with my C10s BOB connected via parallel cable to a UC300 controller.
Seems like the output pins 2-9 have a jumper selectable COM pin for either 5V or ground.
I can't...
Hi all - looking for some help please. I have a C10s BOB configured so the pins 2-9 pins Common connection is 5V ---BUT there is no 5V there.
C10 is externally powered with 5V and there is 5V on...
Title as listed above on Ebay through Saturday