Dear all.
I have read all the posts about the retrofit with centroid. The posts that have been not satisfying thecustomers are from 2099. Do somebody know if the quality and the support increased...
Type: Posts; User: ThiloD
Dear all.
I have read all the posts about the retrofit with centroid. The posts that have been not satisfying thecustomers are from 2099. Do somebody know if the quality and the support increased...
After Energie loss I am not able to get the tape reader running thru the whole tape.
When memory fail sign is red the tape reader starts till the information begins. Then the tape reader stops....
Dear all
Finally I have my Hardinge CHNC nicely running with a allen Bradley 7370 , but in my manual the section is missing where it is explained how I can enter the tool data like offset and...
Finalyy I was able to post the photo
The air is blowing even when the turret is in the down position
Is that correct ?
Thilo
Finalyy I was able to post the photo
The air is blowing even when the turret is in the down position
Is that correct ?
Thilo
Thank you so much JT
I am not able to post aphoto
but it is like you mentioned. It is the Clippard valve for the turret steering.
If the turret sits down after rotation it is blowing...
Hallo
I have just started my CHNC with an Allen Bradley Control
It seems that everything is working fine just the Clippard Valve for the turret blows permanently thru a hole in the aluminum body....
Hallo
I have just started my CHNC with an Allen Bradley Control
It seems that everything is working fine just the Clippard Valve for the turret blows permanently thru a hole in the aluminum body....