Some options for an automatic shutoff on dust collectors in case of fire;
...
Type: Posts; User: wolff2018
Some options for an automatic shutoff on dust collectors in case of fire;
...
Very true, in our case it was in a large warehouse with
A 14 foot ceiling, it was free standing but near a partition
Wall and it caught the wall on fire once it was on fire.
Big issue was it was...
My advice would be make absolutely sure the entire unit and barrel are steel- no plastic, get an automatic device that senses fire on it that shuts the duct in/out off with dampers, and shuts the...
I'm sorry you are not seeing the bigger picture here, as well as the apparent fact that Oneida no longer has that black plastic housed turbine unit with the cardboard barrel- both are now STEEL, what...
A few years late for the opening poster, but our experience was the dust collector caught fire and burned all 4 buildings down to the ground, contents and all, while I rec'd 2nd degree burns on my...
Isn't that just crazy though! after all the measuring tools, checking and rechecking drawings, and going in circles, we discover what the cause was- a loose nut! LOL!
We FOUND the problem after running more test drawings and scraps, drawings by both of us...
We still found about 0.053" of material being left on the bottoms of SOME of the inside cuts as before,...
That's the big mystery! I can see if maybe I used T2 for the rough cut and then used T3 for a finish cut, that making the two tool paths maybe I slipped a digit or something by accident on one of...
Someone suggested I do this;
I'm going to check that to-morrow, I have not calibrated the switch before buf if our "guru" is in to-morrow I'll talk to him, he's done that and resurfacing the...
You bet!
I know I've not set the Z zero with the vac on, maybe that's a procedure I've been missing and forgot about, we always set that Z zero point at the machines' x1y1 corner, which is...
This is specifically where the machine is set to x1xy which we have as x0y0, giving us a 1" gutter allong both sides of the table, so the lower right hand corner out of view is where we have the zero...
I have not specifically looked at that Jim, I might run a test piece and take note of that. I know I looked in the TAP file for the part and it showed the z cut was at 0.0000000 as programmed and...
Hi guys, thanks for the responses, we keep pretty good on resurfacing the spoilboard to maintain flatness, it was done about 10 days to 2 weeks ago, it's one more of the things we'll probably do...
Hi,
I work for a company that has a Cammaster Cobra ATC, CR510, and we use Vcarve Pro and the software that came with the machine, it's been running fine and I got past the learning curve on this...