Reflashing firmware has restored step gen plotting function. Will test further.
Type: Posts; User: jtlapp
Reflashing firmware has restored step gen plotting function. Will test further.
Franc,
Don't know if this helps, but the cable I use with my current VSD-E cards is marked TTL-232R-5V. 6 wires out.
I
Hi,
Reading through the DualDc docs, i would guess that success comes down to your control software on the driving computer. If your software supports all home switches on one input pin.
No two...
I'm using VSD-E drives to convert a Hurco KMB-1. Stock motors have been fitted with encoders as the tac gens are not used with this drive.
The first round of torque tuning produced step response...
:drowning:
I'm in need of a mentor for the HIT 8S lathes who is located in Texas who is willing to show me the basics of the Siemens controls.
Thanks
First rate!
I take it that the roller bearings and ramps are for opening the exhauste dampers under the torch as it travel along the cut.
Al,
Sorry for taking so long to replay, voltage looks low, but the X and Y have are about the same voltage when driven with a power source and the Servomate seems happy with them. Moving the Z...
Al,
+11.56 VDC input 302 RPM 1.03 VDC Tach
-11.56 VDC input 301 RPM 1.02 VDC Tach
+16.16 VDC input 427 RPM 1.45 VDC Tach
-16.16 VDC input 427 RPM 1.45 VDC Tach
+31.7 VDC input 842...
Screwed up and turned the RPC off before I turned off the KMB1. Now when I switch on the power the Servomate and power supply fans start as normal and the display lights up, but the same info is...
My KMB1 came to me with a Electro-Craft 0703-02-089 servo on the Z axis. I've replaced it with different Electro-Craft with the same 0703-02-089 part number. The old motor was tripping the...
Al,
Many thanks. Off to dive through my treasure pile.
John
Does anyone know the correct Electro-Craft part number for a Hurco KMB-1 Z-Axis. I've have a spare motor with an identical electro-craft part number as the motor which came with my KMB-1, but I...