Search:

I have recently purchased anothe Maho. This time a 800E.
I currently have 2 problems.
The Y Axis will not move during the refrence point serch routine.
It will move away from the current position...

Sodickappsguy,
Does the EX21 control have the ability to find the centre of a hole, corner of a block, centre of a groove etc..? Is the same avail on the Mark 25 control. I undrstand as well that...

I curently have an early 80's Makino EC3025. looking to upgrade.
I have seen a 1997 Sodick A530D with EX21 Generator / control & a 1999Sodick A320D with Mark 25 Generator / control. Apart from size...

Hello Burgs,
I assume your problem is occuring during "Powering On". How are you doing this, as the maho's have a specific way. All isolators "ON", E Stops out.
Press M/C / Hydraulics ON (Large...

Hello Mark,
Have you got your machine? Are the problems fixed?
Paul Deady

Marty,
I have sent you a PM. If you wish to contact me. Whereabouts are you.
How old is your M/C
Paul Deady

Amtekinc,
You may want to check thatr the photo electric sensors are clean. One at the top near upper drive rollers and one in the upper head area. If they are dirty can stop wire.
Paul deady

Amtekinc, I too have a Makino EC 3025.
I presume that the wire is correctly fed all the waty through to the Plastic Bin. Are there no alarms or messages like "Back Block Out".
What happens if in...

Hello Zcases,
Did you have any joy in sourcing an achme thread mill. I have to manufacture a 12mm, 2 start, 2.5mm pitch Acme nut in Acetal. I am interested did you source a tool?
Paul Deady

Hello Kotten,
I have not worked on a Maho E M/C with an ATC.
Never the less I would check all Proximity Switches and Limit switches within the ATC. The fault could be a dirty or loose proximity...

I have an older Makino EC 3025 Wire EDM.
The earth and I presume the power cables to the heads and Clamping frame all are Flat Ribbon cables. Due to age and previous owners neglect thay are in a...

I also have a EC3025 with MGN10W.
I use two different technology tables. 1 to start wire then switch to a higher setting after 5-7mm. This seems to work OK for me.
I cut a lot of hardened Tool...

Hello Kotten1,
N20 you have re set or canceled the Automatic Shift Value of Zero Datum Shift G52
N30 you are using the Stored Zero Datum Shift 1 G54

Therefore to cancel G54 use G53, Be aware...

You should try the following,
G51 Cancels the Reset Axis Position (or G52)
G53 Cancels Stored Work Coords (G54 - G59)

Therefore if you are usinfg G54 to G59 in your Prog
G53 X0. Y0. Z0.

If...