Hi,
I have a Emcoturn 342 with GA3 Siemens 810 control. When turning on the machine and later pressing AUX ON the controller looks like it reboots for a few seconds then complaining again that AUX...
Type: Posts; User: mr_ping
Hi,
I have a Emcoturn 342 with GA3 Siemens 810 control. When turning on the machine and later pressing AUX ON the controller looks like it reboots for a few seconds then complaining again that AUX...
Anyone know the name of the pin on the picture ? It supposed to push on the tool gripper on a Brother TC 221. It broke off today in a faulty tool change and I need to replace it. How much must I...
Do they only sell whole machines ?
Seems quite cheap, but the machines they list now are broken I guess ? I mean a s2a for like 5000 is very cheap.
Is that on ebay ?
The tool clamps Ive seen are for the newer machines. Spindle seems to be exotic aswell, a 227 spindle didnt fit (wrong diameter for my bearings).
I had taper wear that I...
Hi,
Ive retrofitted a Brother TC221 that runs pretty nice but Im in need of some parts. Yamazen sells but the price is insanely high.
I need a complete tool turret or the tool clamps/fingers.
...
The machine is from 1986.My guess is that it is well used over the years.
Is it reasonable ?
https://youtu.be/F49kW8TLPBY
theres a movie. I walk in and stop etc.
It was 0.015 before I changed bearings too.
Ive tested extremes, same result. You see that the table moves out 0.05mm when I climb mill and goes back if I stop the cut. When doing light passes...
Its a brother tc225 with retrofitted control.Had it for 6months, always been like this in my possession.
Servos on all axis, 1kw and 1.2kw.
It happens on Y axis climb mill, not on conventional....
6, 8, 10, 12, 16mm. They all chatter if I slot mill 3mm deep or take like 10mm deep in steel with 2mm woc.
Only in X direction climb mill.
Did you fix this ? Got same in my linear rail brother cnc.
Hi
Bought a Maho500C and is retrofitting it now. Noticed backlash was 0.05mm on both X and Y and 0.00 on Z more or less.
I wanna adjust the gibs first since I have some play there. How do ai...
.
Hi some years later... my screen looks the same but in color. Any suggestions ? It varies between severe grsphic gailure to a black / red screen with what looks like an ettoe code.
My machine did the exact same when I had too much backlash compensation on, but sure it can be that the roughing is too near final diameter.
I got a BF30 and I've burned two motors on that one. Both of them burned all plastics inside. Now I use a 1.5kw VFD controlled motor which is much bigger. I disconnected the gear box too.
Looks like backlash caused marks or equivalent ?