Search:

Hello All! I purchased a ZX7045 clone a few years back. It never would run at G-Code feed rating didn't matter what you changed the feed rate to it always ran at ( something like 1.5IPM). The...

Hi there;

I am in process of upgrading my DIY mill with CNC4PC components. ( C76 board with the UC 300 Ethernet system) I also switched from MACH2 to UCCNC. The machine will jog, but only at...

Thanks for the reply.

I am using the C76 BOB with the UC300 Ethernet system from CNC4PC. The Gecko website states that there should be a 470K ohm resister soldered across the encoder + & - pins...

I was able to tune most all the jitters out of the drives one at a time. There is still a small amount of movement ( not entirely sure what to call it when the motor is confused on which count it...

Hello all!

Preface; I have been a tool and die maker for 30 years, some cnc experience. I bought a bench top clone ZX7045 mill completed retrofit. It never ran code at g-code feed rate. Change the...

Hello all!

Preface; I have been a tool and die maker for 30 years, some cnc experience. I bought a bench top clone ZX7045 mill completed retrofit. It never ran code at g-code feed rate. Change...

Hello; I am looking for a gearbox/spindle housing for an Asian ZX7045 mill drill. I am looking to convert to a VFD and spindle. I am looking to gut the housing and retrofit the new VFD driven...

Hello all! I'm new to the cnc retro world. And wanted to purchase a CNC trainer lathe. However I decided that it would be more beneficial in the future to build a 4th axis . I am curious about...

hello;

Is the machine still on the limit switch? Try disconnecting all power and manually turning the motor/axis to get off switch. Then repower and test. It's possible the axis switch stops...