584,866 active members*
5,228 visitors online*
Register for free
Login

Search:

Type: Posts; User: electricgraffix

Search: Search took 0.00 seconds.

  1. Re: Need help with my Torch Height Controller

    Ok guys, after many painstaking hours, I have solved the Chinese torch head controller problem, and this solution is the safe method, still using the 50:1 Hypertherm down scaling. I have taken the...
  2. Re: Need help with my Torch Height Controller

    You are right, 100%. problem is solved, I did some searching and found the solution.

    Here is a video i made for the solution for anybody else who runs into this issue.
    ...
  3. Replies
    8
    Views
    5,444

    Re: hypertherm powermax 85

    Jim, thank you very much!
  4. Replies
    8
    Views
    5,444

    Re: hypertherm powermax 85

    Jim, I would love to get that PDF on how to connect my raw arc voltage.

    thanks,

    Larry
  5. Re: Need help with my Torch Height Controller

    I am using Fastcam - but its not an issue with the g-code. It will do it with the built in library of parts in my controller, as well as custom code. Plus when I do my g-code I cross check to make...
  6. Re: Need help with my Torch Height Controller

    Thanks for the insight Tyler. If the board was bad, would the THC still be getting power? The LED screen functions correctly. Or are you meaning the voltage dividing board in the CNC controller? ...
  7. Need help with my Torch Height Controller

    Hey everybody, thanks for reading my post. I am having a problem with my THC, I am hoping I can locate a sharp person in the community that can help me out.

    Specs:

    Machine: J-CUT 4'x10'
    DTHC:...
  8. Replies
    17
    Views
    977

    Thanks Andy for the useful advise! Should I...

    Thanks Andy for the useful advise! Should I break the spindle in without coolant flowing through the motor while it runs unloaded?
  9. Replies
    17
    Views
    977

    I have a 2.2kw liquid cooled Chinese spindle. My...

    I have a 2.2kw liquid cooled Chinese spindle. My machine is pretty hefty (J-Cut 1325B). This spindle seems to heat up without a load on it! I am still trying to figure out the cooling system that...
  10. I am getting ready to do this same conversion...

    I am getting ready to do this same conversion with a J-Cut 4'x8' CNC Router. I didn't realize NC studio was so junky until I tried to cut with it. Can anybody point me to the right direction of a...
Results 1 to 10 of 10