Hi folks I'm machining a part but require a 12mm end mill to machine a 30 degree angle using the y and z plane. Is it possible to do this using the angle feature i.e. for x and z plane
G0 x50 z2 ...
Type: Posts; User: Timster
Hi folks I'm machining a part but require a 12mm end mill to machine a 30 degree angle using the y and z plane. Is it possible to do this using the angle feature i.e. for x and z plane
G0 x50 z2 ...
I'm writing it on the machine itself, it's a 0.8 rad going into a 1.2 rad and then blending back out to a 0.8 rad
Hi folks as title I have to machine a rad going into a rad of the face of some stainless steel. G41/G42 doesn't work as it's in fanuc easyturn. Tool will be a 0.4 rad 35 degree insert
It's a lathe...
It wasn't on 4 so changed that, after a bit of faffing about I managed to copy all the programs. Thanks for your help ☺
I'm pretty sure it's on that but I'll double check when I'm in work tomorrow ☺
Thanks for the reply, I do have the manuals for the machine and have followed them accordingly. Any other suggestions?
Hi folks I'm having trouble with the above fanuc series copying programs as backup into a memory card.
I've formatted the card successfully on the machine but now comes up with a 086 DR SIGNAL OFF...
Hi there I thought if you put a G41/G42 in the program part of said tool it will cut to whatever radius you program?
The company I work for has recently bought a lynx 220 new, it's very good for working out contours and implementing roughing cycles with it's quick turn package.
A few of us had a weeks training...
Hi folks I'm new to this forum, just come across this thread. Our lynx 220 is around three months old and had a 2116 alarm the other week. I had to remove all live tooling and replace them with...