Search:

Yeah that's "WAY MORE" than what I'm trying to setup!

As I mentioned earlier in post #3




I think the main detail everyone here is over looking is this part.

Well at-least a fairly good idea!

This project is still somewhat of a work in process, So I'm sure there will be a few bumps in the road.

I worked with items that were controlled by Arduinos...

Yeah but they can also be controlled by electrical conductivity as seen in this video at about 2:20 minutes.
https://www.youtube.com/watch?v=U9vQVqfZrGA

In my case I could just connect a wire to...

The router motor is basically a modified hand-held power tool & it's double insulated so there's no ground connection. The motor will be off (DPDT Switch) during the tool zero set process, So there's...

Searching around on a little more I think maybe this standalone 5-pad capacitive touch sensor - AT42QT1070 & a relay board should work out ok with-out the Arduino? ...

Here's a YouTube video showing a Arduino & the KY-036 sensor controlling a relay board that turns a standard light-bulb on & off.
https://www.youtube.com/watch?v=xQxF8tKccgI

I figure it could...

I'm not really sure if I need the Arduino either that's why I'm checking into it.
I could probably get by with a simple touch light circuit like the one attached, But I would think the Arduino based...

I've been lurking around these forums for a year or so just gathering information for now, But I would like to get a CNC someday!

I'm currently working on building a regular router table based on...