As gizmo_454 mention only few can handle the full features of swiss. I use solidworks+solidcam usually but for swiss I was forced to go with something else. I choose Esprit where I found the post and...
Type: Posts; User: dghele
As gizmo_454 mention only few can handle the full features of swiss. I use solidworks+solidcam usually but for swiss I was forced to go with something else. I choose Esprit where I found the post and...
Hello , need help with BIOS config for c32 VII(2004) due to battery failure (without any formal warning).
Initially with the default BIOS settings could not boot due to keyboard missing. I manage to...
Thanks
Is different for M32. Anyhow I found one but it is not exporting coordinates; only Gcode
Need more time to figure it out.
I'm looking as well. Is a Meldas 600 control. The E-32 is not working for me.
Anyone have some post close to so we can modify ?
I thought no one will answer.Thanks a lot for advice.My plan was to disconnect the lines from the pump and inject & air blow some engine oil (which contain stronger detergents) to melt all this...
Zeroing procedure sorted; I finally found the page.
Q For Cincom users: My machine was out of production for more than a year and almost all my axes are dry at the moment;I can apply oil on rails...
As an update: I manage to get Tape Mode on my 10M machine. Cassette ladder was modified by adding G12.3 and SW updated to 1021 SW to allow it to work.
Maybe will help someone someday :)
Just bought a Citizen C32 with Meldas600 and Intelligent motors. I finally manage to get the axis zeroed using procedure and manual jog pressing against end but I can not zero A1, A2, A3( for front...
Hi Guys,
Can anyone help me with a post processor for Citizen Cincom C-32?? I just got the machine and I think Esprit is the easy way forward.Just want to give it a try.
I would prefer SolidCam...
CNC2149 wrote:
" I did a job in 1996 on a 10MA Analog (1020 SW) where I added the DNCI PMC bit (G12.3) to their 3MI compatible ladder and when we attempted to run drip feed, it would result in...
Hi
My machine have a serial port and I can load and save programs but I can not enable drip feed function. I do not have TAPE mode and the machine is using FS3 interface. As far as I red till now...
Any Help guys?? No one? At least somthing to start with.
Thanks
Hi guys,
I know is an old post but is related with drip feed so... I will ned your help and guidnes. I've read very carefully the previous posts and I will describe below all the information about...
Hi guys,
I'm Daniel and I found out and register to this forum because I need some guidness and help. I start building my own design CNC(router) back in 2003. Since then I added to my colection a...