Search:

When using a five flute 8tpi thread mill how can I do multiple passes outward with one turn of the pitch out of the hole. I am doing a 1in. x 8 1in. deep.
Any help would be greatly appreciated The...

I know there are some nice videos on the web site. Haven't had the money to renew the maintenance on my software. Using the PDF is very time consuming especially when I am trying to get a part out...

Yes this does help . Thank you
Solids is the best way to go but I am not that good with that yet. It sure would be nice to have a few basic videos to watch .
Thank you again for the help.

Is it possible to take a full depth of cut and step into the side of part , rather than steps in the Z. I am only cutting three sides or one end.
Have no training on Gibbs running it on the fly. ...

Well guys I feel someone from Mag should step up to do something. Sad part is if operating system should fail they don't have a backup disk or new program to back it up. I already have been through...

Thank you Neal,
I talk to Douglas a lot. Problem is never goes down while they are open. Got it to work but my Z is off. After setting tool lenth cuts air on first pass. Shouldn't have to put a...

Does anyone have a Infamatic NC 200 control . Need to Know how its working for you. The control I have has been a nightmare. Right now can't set up tools getting error wrong tool data. In my tables...

I was afraid of that. Machine is only two years old and have had issues from the start. Bought the extended warranty, not looking forward to the down time when work is trickling back in. Thank you...

Does anyone know how to adjust the draw bar tension. Have a lighting cool thru spindle. Air pressure is fine and checked bleeder filter. The tool doesn't seem to pull in tight enough. when I make a...

Hi Koshy,
Can you get any updates for the infimatic control . You came here and serviced my machine once in buffalo n.y. Mag Technology said they would have to send a service rep. out to do it....

I have a project that i am trying to finish but need a post for my Fadal vmc to use Gibbs 6.11. Can anyone help.
Thank you,
Joemech

I need a little advise on purchasing a older machine MT-V-10 with a cam m2 control. The machine has not been under power for at least 6 months. Is there any common problems that I should be concerned...

I have daewoo 220lc have not had any problems other than what I created. Have cut a boat load of parts and hasn't let me down. would buy another daewoo , exellent machine for the money!

I have a dpc-20 running my shop works great. do not miss the rotory phase converter one bit.