Search:

I will give that a shot. I have never had an issue with this method on Haas, okuma, matsura, and Mori so that's why I am so confused. It is the same standard that has been in 2 of the shops I've...

I touched my tools off manually using a 123 block and make sure to calculate that distance in the z touch off. As for my work offsets I use an edge finder. My 55 and 56 heights are the same but my 54...

Hey guys,

I have 3 work offsets, all tools are set off of G54 Z zero plane (top of complete part) but when I measured the distance between the top of G54 to G55 & G56 (same height) only one of my...

Steve,
Your inbox was full so this is how I'm getting back to you. Send me your email. It might work, but when I sent it too someone with Powermill it didn't work. But maybe we can work on fixing...

So I have MasterCam 2018 and I know about migration wizard but it only goes back 3 versions. So if there is anyone with X8, X9 or 2017 that could take my X7 post file and convert it and send it back...

Hey community,

I have been trying to get a .pst/.post file for a Tormach 1100 for Mastercam. So far I have come up with nothing but endless rabbit holes, I was hoping someone had a .pst file for...

Hey community,

I have been trying to get a .pst/.post file for a Tormach 1100 for Mastercam. So far I have come up with nothing but endless rabbit holes, I was hoping someone had a .pst file for...