thanks for the help
Type: Posts; User: funcutter
thanks for the help
1 have a 5x10 router, i drew up a project on artcam but when i put it in mach3 my x and y are in the wrong directions, i want to know if i can rotate my project with my tool paths without starting...
i keep getting the error "two or more intersections overlap " this is for making a toolpath. i have one cut that is shallow in one direction and a deeper cut going thru that other cut, how do i...
my rpm was 15000, the 3.5k is HP. and it is two flute
not sure what you mean, with a .080 bit i wouldnt think it would what motor i had would make a difference its so tiny. certainly doesnt need much power.
3.5k on spindle and 450b on steppers. i did not notice any miss steps but im new but the machine did exactly the same thing on 8 cuts and all cuts look the same. the machine ramped out instead...
thanks for the help, the machine seems very rigid, i tried looking up on the internet about overshooting with artcam pro and didnt find anything i will try tomorrow and slow it down and see if that...
i have a cnc router and i am cut thin plastic so i am running at 100" min the cut is good. when it goes to finish the circle the machine pulls out about 3/8" early leaving a gap of unfinished...
i have a cnc router and i am cut thin plastic so i am running at 100" min the cut is good. when it goes to finish the circle the machine pulls out about 3/8" early leaving a gap of unfinished...
i have artcam pro and am very new to this. i am cutting a ,080 slot .090 deep in expanded foam pvc i use 100" feed rate and it cuts good but where the tool enters and exits there is an incomplete...