Search:

hi Zax

thanks for all the info. It really sound like i was heading the wrong way. I never thought about vinyl cutter i thought they would be too much money, i am glad you set me straight on that,...

Hi all
its been forever since i have posted here. I have had 4 surgeries since i last posted just can't get the pain pump to keep the pain under control. they have told me now that i am not going...

Hi
I think I have it down to David Steel's plans or the jgro plans and Joes plans. Can any one give the pro and cons of each of these. I want to do carving in oak, cherry, and maple. I have to be...

It was not to hard to tell it to just go in a circle. It would of been nice to have a machine to put all 120 plucker finger into my aluminum spinning base plate.

I don't remember much of g_code...

thanks for the input
I can't wait for the plans to get her. I have a ton of oak door just wait to be engraved. So I need to get this machine done. I can't wait to start I love building things. last...

has any one used two pieces of oak glued together to get your 2v4 oak pieces.or what about putting three pieces of 3/4" oak to make your sides. any pros of cons on using lamented oak. I have tons of...

Hi
I think I have it down to David Steel's plans or the jgro plans. Can any one give the pro and cons of each of these. I want to do carving in oak, cherry, and maple. If there any other plans out...

Hi
I think I have it down to David Steel's plans or the jgro plans. Can any one give the pro and cons of each of these. I want to do carving in oak, cherry, and maple. If there any other plans out...

I need to build a machine that will do engravings in oak, maple, and cherry. The depth of the engraving will be less than an inch deep. Kind of a 3d type engraving.
Thanks
Tim

Hi
How much is Joe's kit? and how much are your plans? I have not read all the post yet on joe's machine but what I have read I like. This is what I want to build. I am only up to page 25. But I...

Hi
I hope I posted this in the right place.
What are the best cnc router plans? I want it for engraving in oak, maple. cherry wood. Max. width would be 16" but would prefer 22"
Max length would...

Hi I am looking to build a cnc router table. work surface must be able to cut 24" wide and 42 to 48" long. and 2 in thick(it doesn't need to cut through 2 " but must be able to handle 2 in thick...