Search:

Does anyone have the parameters for a Kasuga ACE 120?

I have been thinking of replacing my VQC 20/40B M2 controller which is a UF701A. Are there any problems with putting in a UF0701B or C or D version of this controller? I notice that the plug in...

My Mazatrol M2 will run basic milling programs but nothing else. If I have a tap or drill in the program the controller locks up. I have tried changing all of the circuit boards in the cabinet to no...

My Mazak VQC 20/40 running Mazatrol M2 has been stopping in the middle of a program for no obvious reason. No alarms. For a while it would work OK in the morning, but after about 2-3hrs would come to...

I eventually got this going by buying another CPU board for the FR-SX spindle drive and swapping it. Maybe I can work out what is different between the two sometime, but at least it is going for now.

The replacement encoder TT-A-11 seems to have fixed the shuddering. It was fiddly to get access to the screws and work out how to rotate the spindle, but I got there in the end. We machined a few...

Hi Stanislav,

Thanks for your advice. I have a spare tacho. I will try it tomorrow,

Regards

Richard

Hi Sudsy,

I have a similar problem on my VQC20/40. When I tried to move the Z axis the head shudders up and down. Last time I turned the machine on the shuddering started before I moved anything...

Parameters for VQC 20/40B attached.

I have been out of town for a few days. I have a parameter list which I will send tomorrow or the next day.

Thanks for that important piece of information. I have now got all the parameters in place and checked. The machine zero returns, the spindle goes but only to 2000 rpm in the high range and about 30...

I replaced the CPU board on the spindle drive. This seemed to go well but I took so long over it that a battery on the NC side lost volts so that there were a few parameters corrupted. I overwrote...

I am dismantling a Howa NC7. Perhaps the toolholders are the type you are looking for