Try Aliexpress. I have bought the SBU20 for my CNC Router and HGR20 for my CNC late. They work for me....
Type: Posts; User: Poppey
Try Aliexpress. I have bought the SBU20 for my CNC Router and HGR20 for my CNC late. They work for me....
Thanks Jim,
I trid it but see that the torque is 700 N.cm which is far beond the nema 23 motor. I need to find a way to soften up the turret. There may be some misalignment or something after I...
Hi,
I'm getting finished with my slant bed cnc lathe with atc turret.
Just hooked up the stepper motor on the 8 tool atc turret.
The tool change is done by activating an air cylinder, than turning...
ger21
Happy New Year
Yes you are right. It was silly me that did a termination mistake. It´s ok now.
Thank you ger21, Happy New Year!
My problem is that I have set all parameters as per the manual but no life in the motors. I have contact with the board switches are working. When I enter a G code...
Are there any way I can test the card to find who are who of the pins?
Sent from my iPad using Tapatalk
Hi
Does anyone have Mach3 USB Motion Card STB4100?
I bought it on Aliexpress. It´s made by Hongbang Motor Co., Ltd. My question is which pin should I use for axis step and dir?
The manual say 0 on...
Hei
Jeg har tegnet den i Autodesk Inventor så om du har det kan jeg sende deg filene ellers så har jeg en del i pdf. Jeg bor i nærheten av Stavanger og der selger Hillevåg Mek Verksted aluminiums...
Her ligger det noen bilder av prosjektet mitt. Beklager rotet:-)
https://www.flickr.com/photos/31086180@N02/albums/72157663432459922/with/23790621563/
Hei
Jeg har bygget en CNC Router/3D printer. Den er ca 1x1 meter med 300 mm vandring på Z aksen. Jeg bruker rack and pinnion på Y aksen (2 stk) og NEMA 34 stepper motorer, Timing belt på X aksen...
Jeg har ferdig designet på min kombinerte CNC router/3D printer kanskje også plasma. https://www.flickr.com/photos/31086180@N02/sets/72157641007826165/
Viser med K40 80x80 og 40x80 profiler mens...
Er vel noen år for sen med mitt svar men jeg kjøper alu profiler fra KINETIK MSystem - ...seien Sie konstruktiv
I will also brase the frame so it get stiffer than as shown.
Thans LeeWay
You got me into leaving the plasma. Its more nice to have than much of a need. I may get the steel cut elseware.
Than I will focus on 3D printing and may be light routing in...
Hi
I´m new to the forum and would like to discuss and get advices on my 3 in one table. I´m from Norway and use millimeter. The table frame will be built of aluminium profiles. Legs 80x80 mm, X...