Thanks for reply!
i use V1.1 on NANO
attached stimmstock.nc -renamed to stimmstock.txt
Within Fusion360 a post processor is installed form: https://github.com/Strooom/GRBL-Post-Processor/wiki
...
Type: Posts; User: jpascher
Thanks for reply!
i use V1.1 on NANO
attached stimmstock.nc -renamed to stimmstock.txt
Within Fusion360 a post processor is installed form: https://github.com/Strooom/GRBL-Post-Processor/wiki
...
Using Fusion360 with postprocessor (https://github.com/Strooom/GRBL-Post-Processor/wiki) works well if i use other grbl uploaders but not with your Uploader, is there a way you can fix this? Or have...
So i just got to this thread today again and i just want to mention that i use the drivers up to this day, no problem at all. I also use the machine quite a lot.
Thanks James,
i did change the text in may privias comment here. And pleas do have a look at it again the text used now on your website is not correct.
My be you use the following line:
"Only one...
@James Newton
You do have a nice website!
I dont think it should be posted here, may some admin moveds it to a other thread later on after you answerd.
On a table on Your Website Stepper Motor...
Just using a rahther poor Driving circuit with "IRF640 mosfets to drive stepper motor along with 817b optocoupler" is not realy recomendabel.
What is the actual circuit you ar using?
I am new here, and my native language is German. I am a electronic engineer and i have all the equipment to make proper measurements and tests.
I also had intensive look at my Haoyu TB6600.
The...
Mistake, the post above is the correct one! This one can be deleted.