Search:

Hi Jim, I have a Multicam M3000, stepper drives, 2001 year that the control board is bad,can you tell me about your controller,I am looking at the acorn but not sure.

the pendant doesn't load when I power up, checked 5 volt,24 volt and 220 3 phase,
there are 2 red lights on the M24 board , on the top red light reads VERTEX and on bottom left a red light CTS,
I...

So far so good, I changed the Ethernet cord yesterday and seems to have corrected the issue.

yes,static IP , I may change Ethernet cable it is a long,maybe 50' it worked like normal on Friday,no issues . ?
Thank you , John

PC to switch then to machine, Ethernet cable.Thanks

yes,using Multicam job server,I have it on 2 different computers, doesn't make any difference. when I pull up a job keypad will show Validating job , Please stand By, then sometimes it just freezes...

M3000 5 x 10 , 300092308 , M24 board, Ethernet connection
I bought this router used in 2004 and has been nearly trouble free, sometimes when I connect to DNC, I will pull up file to run, hit start...