Welcome friends,, I hope you all are perfect
I am asking for any guide or instructions to set the right communication parameters (port setup) such as speed, bits n' parity,.... on both the PC and...
Type: Posts; User: Mahmoud_hola
Welcome friends,, I hope you all are perfect
I am asking for any guide or instructions to set the right communication parameters (port setup) such as speed, bits n' parity,.... on both the PC and...
Welcome everyone,, I hope you all are doing great
I am in a real need for any help from you people, I am trying to make an Egar250 cnc stone cutting machine work, and this is a brand new case for...
Hey People ....... :stickpoke where are the answers?
I need your help experts. :drowning::drowning:
Hi every one, hope all of you are fine....
I have a problem in CNC turning machine (CTX 510 eco - DMG), the cooling fluid which goes out from the tools in the turret has a low pressure and flow...
thank you bolke alot alot alooooooooooooooooooooooooooot it works finally works you are greaaaaaaaaaat bloke :D :D :D
but i need to understand what is that is that VODO hhhhhhhhhhh
Thank for reply .I'm sorry but the page name is toolchanger or diagnostics, every time I go to this page he ask me (next tool), so could you tell me where I write (enter 6 4 2 enter) cause every...
Hello Bloke, I want to thank you for your response I did as you told me and it looked like the problem was in the ballnut so I changed it and the machine has been ok
But actually I'm facing now a...
Thank you Bloke, I'm going to check the points you stated for me
1- Axis drive belt
2- Angular contact bearings or the ballnut.
3- The locknut for the axis bearings.
and I'll give you the...
Hello Bloke, I'm also want to express about my admiration of your experience and your answers. I have the same backlash problem but my problem is more complicated cause the backlash value in Y...
could you tell me how to use teraterm after preparing the NC program ?
it seems to be I did something wrong, look I will try again and tell you about the feed back.
Is that HSMXpress the cam program for solidworks? and when I use it did I have to select Hurco BMC 20,...
Welcome Gary, I did follow the steps. beginning with perparing the RS cable according to the wiki table, then using teraterm program, and after that I followed the 6 steps. and it works good, But I...
Thanks again Gary, I downloaded the table and I will make the serial cable and try to follow the steps, tomorrow I will give you feed back about what happened with me.
thank you again you really...
Thank you Gary for replying, I will go with this steps accuratly but I have two questions to start.
1- For the pinouts. I have 9-D connector, but I need the configrations of the wire to make it...
Hiiii every one,
I'm new in this fourm, and I wish to find help here, I bought a vertical mill machine "Hurco, BMC 20, Ultimax", and I need to connect it via PC to download programs to the...