I have recently had to reload Mach3 due to need for anew computer
I am running XP.
Previously when setting my tool position I would move the tool to the correct location on the material and then go...
Type: Posts; User: Mago
I have recently had to reload Mach3 due to need for anew computer
I am running XP.
Previously when setting my tool position I would move the tool to the correct location on the material and then go...
Hi guys,
Some pics of the completed Offenhauser model, plans by Ron Colonna.
Took almost 2 1/2 years to build and if I had studied the plans more carefully would have realised that it's a very...
Hi all,
A couple of pics of my almost completed Offy 270.
Pistons, rings and alot of little bits that take the time to finish.
Hope it's complete in a couple of months and is a goer.
...
Bubba, Love that impeller.
I can do the islands one at a time so it's no big deal but I thought Sheetcam could handle more than one at a time.
Thanks,
Mago
Bubba, thanks
You are correct with regard to one island but Sheetcam doesn't seem to recognise two or multiple islands and treats them as pockets.
Appears the way around the problem is to break it...
How do you machine "Islands" in sheetcam?
Hi all,
Great to know that there seems to be some interest in constructing this model. I am about 20% thru construction , hoping, and agree that with lack of part constuctions photos it is hard to...
The replies so far have highlighted the obvious problems in scaling down a full size engine althouh most can be avoided if you are prepared to accept a compromise ie bolt and screw sizes and ignition...
Dynosor,
A well thought out and articulated response.
Nice to see a positive reply to a question.
Hope others take note.
Mago
Millman52,
Thanks for your response. Most of the time the start point selected by Sheetcam is OK but on occasions not suitable. The program does have the facility to move the point before compiling...
Bubba, Thanks for your response.
It was so simple I couldn't believe that I couldn't get it to work.
Problem was that the part drawing had (I suspect) a broken line, tho it didn't show.
A redraw...
Sheetcam selects the cutting start point from the input data.
How do you select another point and not the one selected by Sheetcam?
Stem, Look in Model Engineer from 13 April 2006. Plans and construction notes have been serialised in alternate issues.
I have made it and it runs well. No gears to make and will run as Glow plug...