fuji leh984 c controller and 2 regular 6 wire servo's...However, need a special one for a Hurst DM1026 motor encoder (combination) forgot how to connect servo motors, when I was young I could do it...
Search:
Type: Posts; User: donald_ortega
Search: Search took 0.00 seconds.
-
02-22-2011, 06:24 AM
- Replies
- 5
- Views
- 1,624
need a schematic drawing for following
-
03-23-2009, 10:42 PM
Thread: Electronics my weakest point!
by donald_ortega- Replies
- 41
- Views
- 4,238
good ground is to water pipe.
donald O
Re: if you want a good solid ground, see if their is a water pipe close by and connect the ground wire to a water pipe. Do not connect to any gas pipe!!! -
02-23-2009, 11:26 PM
Thread: X2 cnc finished for now maybe
by donald_ortega- Replies
- 1,044
- Views
- 77,327
Alibre Software shipped in Plastic Bag to Calif
Don
I decided not to purchase the Alibre software for Two Reasons. First It was shipped to me in a Plastic Bag, By UPS, where it was Crushed, and Mauled, and one of the disks were Cracked, and the... -
01-15-2008, 12:50 AM
Thread: X2 cnc finished for now maybe
by donald_ortega- Replies
- 1,044
- Views
- 77,327
To the Master Machinist Hoss
Donald Ortega
[email protected]
Hoss
Re: Thank you for all of your good works and supplying us with these great inventions!
Dear Hoss
Do you have any parts in a kit form, that I... -
10-25-2007, 09:22 AM
Thread: advice on machining wax
by donald_ortega- Replies
- 3
- Views
- 1,054
Try Freemans Machinable Wax In Ohio..google It I...
Try Freemans Machinable Wax In Ohio..google It I Have Had Some Good Results.
Don -
08-30-2007, 06:52 AM
Thread: X2 cnc finished for now maybe
by donald_ortega- Replies
- 1,044
- Views
- 77,327
nice job on the desktop mill: just curious about the cost factor
Donald A. Ortega
RR of e.g. Sec, NYSE
Investment manager
I have looked at this harbor freight mill, which looks like a very fine product, for small parts.
It is probably built for larger...
Results 1 to 6 of 6
