Search:

We are already sorted, thank you.

Sent from my SM-J730F using Tapatalk

Hi all, we are experiencing some problems on our Fanuc Robocut alpha 1iD with Fanuc series 310is-WA control.

We use Edgecam 2016 to do programs for more complex profiles and set tapers and...

Hi All
We are looking into moving to New Zealand and I would like to know what software gets used there most?
I use Autodesk Inventor +HSM for design and programming at the moment, and edgecam...

We have tried this aswell. Had the agents out here this morning they now have our same suspicion that the function was not installed on the machine.
I am waiting for them to get back to me on this...

:D That sand is where big kids go to play but it is not everywhere. we have got lots of other things that are everywhere that I would rather not mention...

We have been told that it is a standard on these machines.... if that is not the case someones bum will eat boot.....

Thanks unfortunately I still get the same alarm.

Hi all

On our okuma 3axis milling machine, MDI mode attempting to do a circular spiral cut:
cut radius 55mm
start point x55 y0 z0 with x0y0 in the center of the radius
end point x55y0z-1 ...

It's a standard 3 axis machine

Hi All, Does anyone have a working post processor for Okuma Control OSP-P300MA-e.

With the generic post the machine won't do circular machining.

Thanks

Will give it a shot tomorrow thanks.

Sent from my GT-I9500 using Tapatalk

We got it sorted. Had to manually input ip address and other network id to not clash with other pc on the network. Created a folder on our server to send the nc programs and then had to set this...

That won't be necessary right now thanks for the offer, we are still to receive training on the machine as it was just installed but we are waiting for tooling, if they cannot sort it then I will...

Hi and thanks for the reply, the network is not a problem as we already have that in place, we will only have two pcs that will need to send nc programs to the machine but not at the same time the...

Hi all, we recently got a Okuma Genos M560-v-e with OSP-P300MA-e control.
It has a plug for a network cable in the back, can we connect it to our work network to be able to send programs from...

Hi I am too much of a novice to be of any help sorry. Maybe try asking your questions in a laser section in its own thread. I have found that gets more attention on other forums.

Sent from my S40...

Hi all, Worked on a Daliah cnc mill 13 years ago and nothing since, also have some knowledge of fanuc robocut wirecutters specifically i0B and i0D. There has been some talk about getting a cnc...