Search:

Does anyone out there have a tacchi lathe.
We have a HD/3,105 LS CNC
I'm looking for.mechanical drawings

12v low voltage alarm, the power supply was rebuilt. What boards can I remove from the rack without losing memory?

Does anyone have a copy of the parameters for okuma Howa ACT 3 with a Fanuc 6 control and an ACT 5L with a Fanuc 11 control.

I need help programming a G73 in inch
Can someone post an example.
Thank You

Swap top cards

Hello
Has anyone upgraded there spindle drive to the Yaskawa A1000
If so could I get a copy of the parameters.
The sheet from Haas does not work.

Whats the part number of the master board

X axis goes into oscillation intermittently then will smooth out.
No mechanical bind, swapped command and feedback cables so i am running off of the y circuit, fault stays with x motor , swapped...

What board is bad and what alarm are you getting?

Does anyone have a copy of the parameters for a mitsubishi spindle drive on a 4020 machine

Reverse 2 of the incoming phases

Have you loaded the 900 option parameters by hand and communication parameters.
then you can upload parameters

Does anyone know where I can get a seal kit for the hdyraulic pump on the Lynx 210
Its a Rotor Pump JRPV-15-L-01
Its fitted on a KIR hydraulic unit KIR15P-11T-22M-A

I would check the fanuc power supply, it has an alarm relay that can be used to latch the power on

Check the main fuses the alarm fuses are in parallel the main fuses, they indicate when the main fuses are blown

Does anyone have a Johnford VMC2020 with a Fanuc 0 control.
I am looking for a wiring diagram, the factory had a fire and lost wiring diagram for this machine.

Have you checked for 24vdc at the switches on the operator panel

We have a Yang SL20 with a Fanuc 0i control
The ladder requires a password to view.
Does anyone know the password????

Did you load the parameters in the spindle drive

Anyone have a manuals for the Fanuc 420iR in pdf format they are willing to share?

Does anyone have manuals for the Fanuc 420iR in pdf format they are willing to share?

Turn on power holding in RESET and DELETE pushbuttons to clear program memory

Anyone know the option parameter for Tool Offsets
We have the Yasnac i80 control.

Does anyone have a copy of the parameters for a Mighty Comet VMC1000P with a Meldas 300 control

Look under the spindle board there is a switch to set for 200v or 220v.
Set it to the voltage near yours

Does anyone have a copy of the 412 or 414 software for the 0A control they can email me?

Swap any 2 phases of the incoming 3 phase power to the machine

Remove wires from the righthand side of power supply (make sure you mark them first) Remove white connector. Turn on control and check voltages on power supply, if you have no output voltages, check...

I was working on the same problem here. I tested the drive it ran fine. With motors disconnect I still had the same HC alarms both axis. With dummy plugs connected to servo control board I still had...

Does anyone have a copy of the parameters for an SMG V48 with a Fanuc 0M control?