Search:

Sold

I parted out my Anilam 3000M machine during an upgrade and have listed all the parts on ebay if anyone is interested. Thanks
...

HAAS HA5C 17 PIN ROTARY INDEXER W/ MANUAL CLOSER AND HAAS S5C CONTROLLER | eBay

After more research it seems this motor was used in a "Star-Delta" configuration. The "Star" or WYE or "Y" can start the motor with less current draw but doesn't reach full torque potential in this...

Hi, thanks for the reply. Actually the motor can be wired for either WYE or Delta in either 220 or 440V.

I am definitely using 220 since it is what my line voltage is. The question is what would...

Here is the info....

10hp 3 phase induction motor
20hp Hitachi VFD
Going to wire it for Single phase on the line side
I posted a picture of the tag for the motor and the wiring configurations...

Hi All,

I can't seem to figure out where I should be posting my question.

I have a Alliant knee mill with a 3 axis Anilam cnc controller. I am looking for info, help or recommendations for...

I don't have any specific knowledge related to what you are doing. Does the Dos floppy have an autoexec.bat and/or a config.sys? if so you might try duplicating the info on the XP machine. Here is...

Install a program called DosBox. You can download it here... DOSBox, an x86 emulator with DOS

Then you need to configure it to make it easy to run the Anilam offline program.

Go to "Start"...

I found the download here... Mechanical Engineering Lab - cnc

About half way down the page you will find the download link and the instructions to install it.

Depending on your operating system...

I found the download here... Mechanical Engineering Lab - cnc

About half way down the page you will find the download link and the instructions to install it.

Depending on your operating system...

Seems the question was too hard. Maybe this would be an easier question ... can someone recommend a good forum to ask questions on?

I am looking to fit a Jet JMD-18 mill/drill with a CNC system. I would also like to replace the original 2 HP motor with something I can control the speed on with the CNC system.

I have been...

Thanks for the detailed reply, it has spawned more questions.

In a Servo based upgrade is gear reduction required? I noticed that Alex_Cole's upgrade uses a belt pulley system and kel1 uses a...

I have read all the pages of this thread, checked out all the links and video and now am researching this same project but have a few questions.

About me. I have a computer and electronics...