Hi Chris
Thanks for the procedure. It solved the single block problem I had.
It's amazing how simple it was.
Thanks again
Type: Posts; User: s_itzcovitz
Hi Chris
Thanks for the procedure. It solved the single block problem I had.
It's amazing how simple it was.
Thanks again
Hi Jim,
I know that 7 years have passed since this post, but maybe you're still here and would see my question.
I have a TV-400 machine with the same Meldas M50 controller with the touch screen...
Hi krisxone,
I have a TV-400 with the same single block problem.
Could you please share the GOP memory rest procedure?
Would appreciate it.
Thanks Von
Actually I have a model number that should fit to my machine.
The machine is: S280#1058
The encoder model: RAA-67-8-N
It is 8 positions encoder
NPN type
6mm shaft
Thanks MisticMonkey,
The encoder you mentioned does look like it would work.
Do you have the electrical drawing of the S280N?
If you do, could you please send me the page of the encoder's...
Thanks for you reply
The rotary encoder has 5 bits.
The encoder outputs a binary code using these 5 bits.
The encoder also has a strobe bit that is used to synchronize the encoder outputs with...
Hi
I have a lathe Doosan S280 with 8 stations turret.
The rotary encoder of the turret is broken and needs to be replaced.
The problem is that there is no manufacturer name or model number on it...
Thanks Micheal,
Actually I have already solved the problem.
The problem was with the GAP cable. It was loose and hanging on a thread.
After replacing the GAP cable the touch function works...
Hi there,
I'm a service engineer and I have a problem with a U32 MGW-J1 wire cut machine.
The problem is with the TOUCH function.
If I try to find a hole center or a workpiece edge, the...