Search:

Yes, as you told me to choose under 2mH this is good choice and is not much more expensive that mine 269 oz.in and are 400 oz.in, so i will use them!
Thank you

Hi friend,
Yes im going to use 16mm belt, and i will look for motors with larger shaft.
And about the motion system, what you think about SBR16UU linear bearing block on steel/aluminum tubing, can...

Thanks!!
Can you just take a look at this motor..

https://www.omc-stepperonline.com/nema-23-stepper-motor/nema-23-bipolar-1-8deg-2-83nm-400-oz-in-4a-2-26v-57x57x84mm-8-wires.html

Thanks man!!

Thanks friend, i'll take a look at those psu, gecko is good but expensive, and i dont want to spend a lot of money, this is however diy cnc, and i think 269 oz.in will be ok even with bigger...

Thanks friend, those electronics are good but expensive and i dont want to spend much money, and as i said this is a diy cnc build i think that 269 oz.in motors will be ok for cutting wood with...

Thanks peter, i want to use 20mm wide belt, but maybe 16 is enough.

Yes but on 100 ipm it will have enought force i thing!?
I dont know did i can connect spindle on arduino, if i can i'll think about the spindle and i will go with 12mm ballscrew.
But one friend...

About the stepper inductance, i was looking and all steppers are about 4-5 mH, how much inductance will be good?, and i want my router to cut with about 100 ipm, its not that fast.
And is not a...

Hi guys, i want to build 120cm x 80cm cnc router, and i have few questions?
I want to use 4 x nema 23 stepper motors (2 on X axis) 269 oz.in 2.8A 3.2V, 4 x TB6560 12-36VDC max 3A stepper drivers, 1...